Part of our Horizon family of products, the Fault Thrower provides a means of deliberately introducing a phase to earth fault in order to ensure remote end tripping of a circuit breaker, assuming pilot wires are not available for intertripping.
The need to operate the remote circuit breaker can be due to equipment faults, such as thermal protection or low level fault currents that cannot be detected by the remote protection.
A typical application is with transformer feeders to enable the remote feeder breaker to respond to the transformer local fault detecting relays, such as Buchholz protection, local earth fault protection etc.
|Fault Thrower datasheet|
- Superior, proven technology using a single phase vacuum interrupter driven by a magnetic actuator for fault initiation
- The switch is housed in an aluminium tank, dielectric insulation is provided by SF6 gas
- Connection to the system is achieved by either a separable connector or open terminal bushing
- Manual release of the switch is available within the control cubicle housed under the tank
- The fault is ‘thrown’ through the aluminium tank, two earth points are provided for safely earthing the equipment steel work and to provide a fault path
|Short Circuit Making Current||kA||25|
|Impulse Voltage Withstand||kV||170|
|Power Frequency Withstand (Wet & Dry)||kV||80|
|Control Voltage||V dc||110 (48 & 220 optional)|
|Rated Frequency||Hz||50 / 60|
|Rated 3 sec Short-Time Current||kA||25|
|Peak Short Circuit Making Current||kA||63|
|Peak Withstand Current||kA||63|
|Internal Arc (EATS 41-36)||kA for 1s||31.5|
|Fault Making Time||190ms|
|Endurance at 25kA||50 makes|
|Temperature Range||˚C||-50 to +50|